Power Box 4DThe 4D is very similar to the 4X but is designed to provide an 'In' and 'Thru' on one side of the box and three outlets on the other. This makes it convenient to daisy chain the units, leaving the three Power-Con outlets conveniently available on the same side for trade show booths or for stage perimeter connectivity.
Power Cube 4-E+A/C is supplied to the Power Cube 4E+ through a 20-Amp PowerCON inlet connector, directly wired to a 20-Amp PowerCON outlet. This permits multiple Power Cubes to be connected end to end on a single circuit. On each of the open ends of the extruded housing is an Edison 15-amp Duplex Receptacle with its own dedicated 10-Amp supplementary circuit interrupter (Breaker) and power indicator lamp. Each duplex receptacle has a total maximum load of 8-Amps.
Power Cube 4-ESA/C is supplied to the Power Cube 4ES through a 20-Amp PowerCON inlet connector, directly wired to a 20-Amp PowerCON outlet. This permits multiple Power Cubes to be connected end to end on a single circuit. Both the inlet and outlet PowerCON connectors are recessed into the middle of the Fly-track on each side of the box. This places the receptacles at 90 degrees to the PowerCON inlet and outlet. On each of the open ends of the extruded housing is an Edison 15-amp Duplex Receptacle.
Power Cube 4EThe Power Cube 4E model is a passive A/C Splitter device, containing no active components or supplementary circuit interrupter (breaker) devices. A/C is supplied to the Power Cube 4E through a 20-Amp PowerCON inlet connector, directly wired to a 20-Amp PowerCON outlet. This permits multiple Power Cubes to be connected end to end on a single circuit. All PowerCON inlets and outlets are parallel connected supporting a combined maximum electrical load of 12-16 amps.
Power Cube 4XThe Power Cube 4X is a passive A/C Splitter device, containing no active components or supplementary circuit interrupter (breaker) devices inside. The supply inlet is a 20-Amp PowerCON that is parallel-connected with 12 Gauge wire to four (4) 20-Amp PowerCON outlets. On one end of the extruded housing is the PowerCON inlet with an outlet on each side of the inlet power connector. Parallel connected to the inlet connector is a status indicator lamp.
DISTRO (SKU: 10042)This is a break-out box that connects the first two contacts (pin 1+, 1-) of an NL4 connector to the first two contacts (pin 1+, 1-) of an NL4 and the other two contacts of the first NL4 connector (pin 2+, 2-) and connects them to the first two contacts (pin 1+, 1-) of a second NL4 connector.� ~ This has the same wiring as a COMBO that uses all NL2/Combo connectors. ~ Applications: This enables two (2) full range speakers to be connected to a single four (4) conductor speaker cable.
MATRIX (SKU: 10082)The MATRIX is an adaptor box that breaks out an NL8 into two (2) NL4’s. The first half of the NL8 connector (Pins 1+, 1-, 2+, 2-) connect to the same pins on the first NL4 connector. The second half of the NL8 (Pins 3+, 3-, 4+, 4-) connect respectively to Pin 1+, 1-, 2+, 2- of the second NL4.
